3d-Printed Microscopes

This site contains resources related to learning about computational microscopy by building your very own 3d-printed microscope based around a Raspberry Pi single-board computer and a Raspberry Pi camera module.

Acknowledgements

This work is based on the work of Tomas Aidukas et. al. in their paper “Low-cost, sub-micron resolution, wide-field computational microscopy using opensource hardware.” The paper can be found here.

Figure 1: The paper which inspired this project. (link)

Where to Start

You can find information about getting started on the Labs page.

Figure 2: A photo of the 3d-printed microscopy platform.

This research was supported by the National Science Foundation under Grant No. 2238365. Any opinions, findings, and conclusions or recommendations expressed in this material are those of the author(s) and do not necessarily reflect the views of the National Science Foundation.